It is equipped with an internal programmable alarm relay, to run a generator when needed or to turn off devices when the battery voltage exceeds programmable boundaries. Hi guys, I own a Xantrex Inverter/Charger, and I am in the stage of creating a detail schematics for my campers electrical system, and I just realized if. This means that at 500 amps there will be a 50 mV drop across the shunt. The Xantrex communication kit or roughly translated to as multiple twisted-pair wire runs another 104.99 at Defender. This shunt is a 500 amp 50 millivolt shunt. The Xantrex monitors do not come with the wire to hook it up, just the shunt. A second battery input is also provided to monitor voltage on a second battery. A shunt reads the loads on the system as measured as voltage drop, in mV levels, across the shunt. Using a clear backlit LCD Display and an intuitive user interface, all parameters can be recalled with just a button press. An optional intelligent shunt provides a simple fuel gauge capability that displays amp-hours consumed from a selected battery bank. The LinkPRO selectively displays voltage, charge and discharge current, consumed amphours, remaining battery capacity and the time remaining of your battery bank. A new shunt selection feature enables the LinkPRO to measure currents up to 10,000 Amps. I see a couple of advantages to the Victron monitors with blue tooth capability.
#Xantrex shunt software
High performance measuring circuits, along with complex software algorithms, are used to exactly determine the remaining battery capacity. Unless I missed something I didn't see anywhere in the specs for the Renogy that is has blue tooth capability like the Victron BMV-712 or the newer and less expensive Victron SmartShunt which runs 125. Note: The LinkPRO Battery Monitor is the direct replacement of XBM Battery Monitor with expanded features.ĭefining the amount of energy available in a battery is a complex task since battery age, discharge current and temperature all influence the actual battery capacity. It is equipped with an internal programmable alarm relay, to run a generator when needed or to turn off devices when the battery voltage exceeds programmable boundaries. It selectively displays voltage, charge and discharge current, consumed amphours, remaining battery capacity and the time remaining of your battery bank. Xantrex support confirmed 18 AWG wire is adequate for the. The LinkPRO can measure currents up to 10,000 Amps. The system depends on a component, a shunt, that goes in line with the negative side of the battery.
0 kommentar(er)
